User manual

Display
R&S
®
RTO
112User Manual 1316.0827.02 ─ 06
you to perform phase shift measurements, for example. You can display up to four dif-
ferent XY-diagrams.
XY-diagrams can be used to display the IQ representation of a signal.
4.3.1 Displaying an XY-diagram
You can create the diagram from active waveforms with drag&drop, or use the dialog box
for setup.
To display an XY-diagram with drag&drop
Prerequisites: The source waveform for the y-axis is active in a diagram, the source
waveform for the x-axis is either active or minimized.
1. Drag the x-axis waveform to the lower left corner of the diagram with the y-axis
waveform.
2. Drop the icon when it overlaps the left and lower diagram borders.
The diagram is converted into an XY-diagram.
To set up an XY-diagram
1. On the "Display" menu, tap "XY-diagram".
2. Activate the "State" option.
XY-diagram