User manual

Display
R&S
®
RTO
110User Manual 1316.0827.02 ─ 06
Horizontal mode
Defines whether absolute or relative values are used to specify the x-axis values.
SCPI command:
LAYout:ZOOM:HORZ:MODE on page 503
SEARch:RESDiagram:HORZ:MODE on page 637
Start / Relative start
Defines the lower limit of the zoom area on the x-axis.
SCPI command:
LAYout:ZOOM:HORZ:ABSolute:STARt on page 504
LAYout:ZOOM:HORZ:RELative:STARt on page 505
Stop / Relative stop
Defines the upper limit of the zoom area on the x-axis.
SCPI command:
LAYout:ZOOM:HORZ:ABSolute:STOP on page 504
LAYout:ZOOM:HORZ:RELative:STOP on page 506
4.2.3.3 Position/Range
In the "Position/Range" tab, you specify the x- and y-position of center point of the zoom
area plus a range for the x- and y-axes; the area defined by that point and the ranges is
zoomed.
Vertical mode
Defines whether absolute or relative values are used to specify the y-axis values.
SCPI command:
LAYout:ZOOM:VERTical:MODE on page 506
SEARch:RESDiagram:VERT:MODE on page 638
Zoom