User manual

Display
R&S
®
RTO
108User Manual 1316.0827.02 ─ 06
4.2.3 Reference for Zoom
The zoom area, i.e. the section to be enlarged, can be defined using two different meth-
ods:
●
Specifying start and stop values for the x- and y-axes; the acquired data within those
values is zoomed.
●
Specifying the x- and y-position of one point in the diagram plus a range for the x-
and y-axes; the area defined by that center point and the ranges is zoomed.
Note that the fields in this tab only become editable after you have created a zoom area
using the "Zoom" tool in the tool bar, or after you have created a new zoom definition via
the "Add" icon in the dialog box.
4.2.3.1 Zoom Functions on the Toolbar
Hardware zoom
Changes the instrument settings - horizontal and vertical scales as well as trigger level
and offset - to display a part of the diagram in greater detail.
Zoom
Displays a magnified section of the diagram in an additional zoom diagram. It is a display
zoom, instrument settings are not changed.
Touch and hold the zoom area to open the "Zoom" dialog box.
SCPI command:
LAYout:ZOOM:ADD on page 502
Coupled zoom
Creates a coupled zoom area and its related zoom diagram. If you change the size of
one zoom area, the size of all coupled zoom areas is changed as well.
SCPI command:
LAYout:ZOOM:ADDCoupled on page 503
4.2.3.2 Start/Stop
The "Start/Stop" tab allows you to specify start and stop values for the x- and y-axes. The
acquired data within those values is zoomed.
+
+
-
Zoom