User manual

Display
R&S
®
RTO
97User Manual 1316.0827.02 ─ 06
● Assigned color table
Remote commands
The following remote commands are used to configure color tables:
DISPlay:COLor:PALette:COUNt on page 495
DISPlay:COLor:PALette:ADD on page 494
DISPlay:COLor:PALette:REMove on page 494
DISPlay:COLor:PALette:POINt:INSert on page 495
DISPlay:COLor:PALette:POINt:ADD on page 495
DISPlay:COLor:PALette:POINt[:VALue] on page 495
DISPlay:COLor:PALette:POINt:COUNt on page 496
DISPlay:COLor:PALette:POINt:REMove on page 495
DISPlay:COLor:PALette:COUNt on page 495
4.1.3.3 Diagram Layout
On the "Diagram Layout" tab, you define the basic diagram layout and the appearence
and behavior of the signal bar.
Show grid
If selected, a grid is displayed in the diagram area. A grid helps you associate a specific
data point to its exact value on the x- or y-axis.
SCPI command:
DISPlay:DIAGram:GRID on page 497
Display Customization