User manual

Display
R&S
®
RTO
95User Manual 1316.0827.02 ─ 06
Note: Use of color tables. The exact mapping of the cumulative value occurences
according to the assigned color table is guaranteed only if the intensity is set to 50%. All
other intensity values falsify the mapping but may improve the visibility of the signal. See
also: chapter 4.1.2.1, "Editing Waveform Colors", on page 89.
SCPI command:
DISPlay:INTensity on page 493
Style
Select the style in which the waveform is displayed:
"Vectors"
The individual waveform points are connected by a line.
Define the strength of the line using the INTENSITY knob on the left
side of the screen.
"Dots"
Only the individual waveform points are displayed. Waveform sample
points are the ADC sample points and additional interpolated points if
"Interpolated time" is used for resolution enhancement. To see the dots
of one waveform, perform one acquision with RUN N× SINGLE and N=1
("Average count" = 1). During continuous acquisition, or a RUN N×
SINGLE acquisition with N > 1, the dots of multiple subsequent wave-
forms are displayed on the screen, and the waveform on the screen
might look like a line.
Consider also the "Interpolation mode" on page 33.
SCPI command:
DISPlay:DIAGram:STYLe on page 493
Color
Shows the current color of the selected waveform. To change the color, tap the button
and select a color. The color of the waveform, of its signal icon and of the illuminated
keys is adjusted to the new color.
Use color table
If enabled, the selected waveform is displayed according to its assigned color table.
If this option is disabled, the default color is displayed, and the intensity of the specific
signal color varies according to the cumulative occurance of the values.
SCPI command:
DISPlay:COLor:SIGNal<m>:USE on page 494
Assigned color table
Adjust the waveform colors to suit your preferences. For each of the following waveform
types you can assign a suitable color table:
●
each waveform of any channel
●
a reference waveform
●
the results of a mathematical function
●
a stored measurement
●
an xy-diagram
The following default color tables are provided:
●
"Temperature": shade of color changes gradually from blue (low temperature) to red
(high temperature) with increasing cumulative occurance.
Display Customization