User manual

Display
R&S
®
RTO
94User Manual 1316.0827.02 ─ 06
4.1.3.1 Signal Colors / Persistence
The "Signal Colors / Persistence" tab contains settings for the general display of wave-
form data.
Enable persistence
If enabled, each new data point in the diagram area remains on the screen for the duration
defined under Persistence time, or as long as Infinite persistence is selected.
If disabled, the signal value is only displayed as long as it actually occurs.
SCPI command:
DISPlay:PERSistence[:STATe] on page 492
Infinite persistence
If persistence is enabled, each new data point in the diagram area remains on the screen
infinitely until this option is disabled.
SCPI command:
DISPlay:PERSistence:INFinite on page 492
Persistence time
If persistence is enabled, each new data point in the diagram area remains on the screen
for the duration defined here.
SCPI command:
DISPlay:PERSistence:TIME on page 493
Reset
Resets the display, removing persistent values.
SCPI command:
DISPlay:PERSistence:RESet on page 493
Intensity
This value determines the strength of the waveform line in the diagram. Enter a percent-
age between 0 (not visible) and 100% (very strong). The default value is 50%.
You can also use the INTENSITY knob on the left side of the screen to adjust the wave-
form intensity directly.
Display Customization