User manual

Display
R&S
®
RTO
89User Manual 1316.0827.02 ─ 06
●
Single event: single events and very seldom events appear yellow, a higher cumu-
lative occurance is shown with blue color. This view helps to indentify specific events.
Dialog boxes and result boxes
You can configure the font size, contrast and transparency in dialog and result boxes.
Thus, you can optimize readability or keep track of the waveforms while changing settings
in dialog boxes.
4.1.2 Adjusting the Display
To change the diagram name
► Double-tap the diagram tab name. The on-screen keyboard opens to enter the new
name.
4.1.2.1 Editing Waveform Colors
For each waveform, you can set a waveform color, or you define a color table that speci-
fies which waveform points are displayed in which color. You can use one of the default
color tables, or define your own table according to your needs. You can also edit the
default color tables.
After you define a color table, you must assign it to the waveform it is to be used for, and
enable its use.
The exact mapping of the cumulative value occurences according to the assigned color
table is guaranteed only if the intensity is set to 50%. All other intensity values falsify the
mapping but may improve the visibility of the signal.
See also: "Intensity" on page 94.
For details on signal color settings, see chapter 4.1.3.2, "Color Tables", on page 96.
To change a waveform color
1. On the "Display" menu, tap "Signal Colors / Persistence".
2. Under "Color table assigment", select the tab of the waveform for which the color is
to be changed.
3. Tap the "Color" button.
4. In the "Adjust Colors" dialog box, select a predefined color, or define any other RGB
color with "Userdefined Colors".
To edit a color table
1. On the "Display" menu, tap "Color Tables".
2. Under "Edit Color Tables", select the color table you want to edit.
Display Customization