Specifications

XBee®/XBee‐PRO®SERFModules
©2009DigiInternational,Inc. 92
ZigBee Register Joining Device
Frame Type: 0x24
A KY command can be used to set the new device's initial link key." as "A KY command can be
used on a new device to set its initial link key." Registers a new device into the trust center's key
table. A KY command can be used to set the new device’s initial link key.
Frame Fields Offset Example Description
Start Delimiter 00x73
Length MSB 1 0x00
Number of bytes between the length and the checksum
LSB 2 0x1D
Frame-specific Data Frame Type 30x24
Frame ID 40x00
Identifies the UART data frame for the host to match with
a subsequent TX Status. If set to 0, no response is sent.
64-bit Destination
Address
MSB 5 0x01
Set to the 64-bit address of the destination device.
60x02
70x03
80x04
90x05
10 0x06
11 0x07
LSB 12 0x08
16-bit Destination
Network Address
MSB 13 0xFF
Set to the 16-bit address of the destination device, if
known. Set to 0xFFFE if the address is unknown.
LSB 14 0xFE
Options 15 0x00 Set to 0.
Key
16 0x01
The initial trust center link key of the device, settable up
to 16 bytes. If less than 16 bytes are supplied, the upper
unspecified bytes of the key will be zero padded.
17 0x02
18 0x03
19 0x04
20 0x05
21 0x06
22 0x07
23 0x08
24 0x09
25 0x0A
26 0x0B
27 0x0C
28 0x0D
29 0x0E
30 0x0F
Checksum 31 0x42 0xFF - the 8 bit sum of bytes from offset 3 to this byte.