MSDS

B3C Fuel Solutions LLC
108 Daytona Road
Conway, SC, USA 29526
[phone]
Diesel Mechanic in a Bottle
Page 5 of 11
SDS Preparation Date (mm/dd/yyyy): 04/29/2013
SAFETY DATA SHEET
Use in a well-ventilated area. Wear suitable protective equipment during handling. Do
not ingest. Do not breathe mist/vapors/spray. Avoid contact with skin, eyes and
clothing. Keep away from heat, sparks, and open flames. Wash hands thoroughly after
handling. Avoid contact with incompatible materials. Do not eat, drink or smoke when
using this product.
:
:Conditions for safe storage
Store in a cool, dry, well-ventilated area. Store away from incompatibles and out of
direct sunlight. Storage area should be clearly identified, clear of obstruction and
accessible only to trained and authorized personnel. Inspect periodically for damage or
leaks. No smoking in the area.
:
Incompatible materials
Strong oxidizing agents; Acids; Bases.
SECTION 8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Exposure Limits:
Chemical Name
STELPEL
STELTWA
ACGIH TLV
OSHA PEL
2-butoxyethanol
N/Av
50 ppm ; 240
mg/m³
N/Av20 ppm
Toluene
300 ppm (Ceiling)200 ppmN/Av20 ppm
Exposure controls
Ventilation and engineering measures
:
Use general or local exhaust ventilation to maintain air concentrations below
recommended exposure limits.
Respiratory protection :
Respiratory protection is required if the concentrations exceed the TLV.
NIOSH-approved respirators are recommended. Confirmation of which type of
respirator is most suitable for the intended application should be obtained from
respiratory protection suppliers.
Impervious gloves must be worn when using this product. Advice should be sought
from glove suppliers.
The following glove material(s) are recommended: Barrier; Viton; Tychem; Silver
Shield™.
The following glove material(s) are not recommended: Natural Rubber; Neoprene;
Polyvinylchloride; polyvinyl alcohol; Butyl rubber.
:Skin protection
Chemical splash goggles are recommended. A full face shield may also be
necessary.
:Eye / face protection
Other protective equipment :
Wear resistant clothing and boots. Other equipment may be required depending on
workplace standards. An eyewash station and safety shower should be made available
in the immediate working area.
General hygiene considerations
:
Avoid breathing vapour or mist. Avoid contact with skin, eyes and clothing. Do not eat,
drink, smoke or use cosmetics while working with this product. Upon completion of
work, wash hands before eating, drinking, smoking or use of toilet facilities. Remove
and wash contaminated clothing before re-use. Do not take contaminated clothing
home.
Clear, light tan liquid.
:
Appearance
SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES
:
Odour
Petroleum solvent odor.
Odour threshold :
No information available.
:pH
No information available.
-68°C / -91°F
:Melting/Freezing point
157 - 197°C / 315 - 387°F
:
Initial boiling point and boiling range