Specifications

6.8 Using the controls on the

push-button panel for ON-OFF

distributors

6.8.1 Enabling the controls

In order to use the controls provided on the basket, you must

ﬁ rst enable the controls by rotating the knob, that enables the

controls from the basket (Fig. 26-G0000, pos.A), from position

“0” to position “1”.

Turn the basket control enabling knob to position “0”:

• all controls present on the basket will be disabled.

Turn the basket control enabling knob to position “1”:

• You will enable the controls from the basket.

• The basket movement controls are disabled from

machine cab.

• If the machine is provided with stabilizers and the

movements are blocked.

• The machine cannot perform any further movement.

6.8.2 Switching on the machine from the

basket

 DANGER

Before using the basket, check that all basket

doors are properly closed and all the operators

inside the basket are properly fastened with

the appropriate safety devices.

 WARNING

Before starting the engine, check that the

emergency stop push-button (Fig. 27-G0000,

pos.1) is not pressed and the knob that enables

the controls from the basket is in position “1”

(Fig. 27-G0000, pos.2).

In order to start the machine’s engine, turn both start knobs

simultaneously (Fig. 27-G0000, pos. 3A and 3B) for a few

seconds, until the engine starts.

When the engine starts, the green pilot light of the work area

turns on (Fig. 27-G0000, pos.4). The pilot light will remain lit as

long as the basket will operate within the allowed work area.

 ATTENTION

If the pilot light of the work area does not

turn on at engine startup, bring the basket in

safety conditions.

26- G0000

27- G0000

3A 3B