Specifications

66
5.5.4 Load limiter *
* The load limiters are not provided on the aluminium
baskets with the codes BUD6341 and BUD6342 in
compliance with UNI EN 280:2005 Directive.
The load limiter (Fig. 4-F0100) blocks the boom movement in
the event of overload, and it also enables an acoustic signal
and prevents any movement of the push-button panel. In
order to exit this alarm condition, you must bring the load
inside the basket within the limits set by the Manufacturer.
 ATTENTION
For the baskets that do not require a load
limiter, the operator must ensure that the
maximum allowed load will not be exceeded.
 DANGER
Do not under any circumstance exceed the
maximum allowed load
5.5.5 Area limiter
This device (Fig. 5- F0100) limits the boom extension according
to the angle thus defi ning the basket operating area (see the
bearing-capacity diagrams given at the end of the manual).
The area limiter consists of an electronic device connected
to an angle/extension sensor. The basket, provided with a
classical push-button panel or a radio control support, is
equipped with a green pilot light that signals the position
of the basket within the work area. After the limits of this
area have been reached, the pilot light turns off and the
movements that may be dangerous for that position, are
stopped automatically.
5.5.6 Emergency pump
If there is no driving force, the boom can be extended and
retracted by means of the pump located on the rear side
of the machine (Fig. 6-F0100); to carry out this operation,
proceed as described in the “Emergency procedures” section
of this manual.
5- F0100
6- F0100
4- F0100