Specifications

Mandatory controls that must be made at 0 hours at the  rst
installation of the equipment
Closure due to door gravity during ascent/descent (on baskets) o
Control of the machine / equipment for the presence and state of preservation safety
Decals
o
Control of the machine \ equipment for the presence and state of preservation of
Bearing capacity diagrams
o
Control of the machine \ equipment for the presence and state of preservation of Use
and maintenance manual
o
Control of the machine \ equipment for the presence and state of preservation of
Nameplates
o
Ascent/descent limit switches (if present) o
Load fastening hook (if present) o
Load limiter (if present) o
Pull limiter (if present) o
Front infeed micro switch closed (if present) o
Micro switch for detecting the locking pins (if present) o
Maximum hydraulic plant pressure (if present) o
Emergency stop button (on baskets) o
Hooking points for safety harnesses (on baskets) o
Anti-collision sensors (if present) o
Spirit level calibration (if present) o
Extensimeter transducer (if present) o
Shut-off valve (if present) o
Load check valve (if present) o
Checking the compliance of machine work area with the equipment installed o
Checking the compliance of machine operating mode with the equipment installed o
Checking the operation and integrity of electrical connections and circuits o
Check general integrity and state of wear of the equipment (framework, cables, hooks,
chains, ropes, hydraulic pipes, electric cables, end run, transducers, strain gauges, radio-
control)
o
Control sheet no
. . . . . . . . . .
Control date
. . . . . . . . . .
Machine serial number:
. . . . . . . . . .
Name of control engineer
. . . . . . . . . .
Equipment code
. . . . . . . . . .
Name of control company
. . . . . . . . . .
Controls Notes
CONTROL REGISTER
1 / 2 TO BE CONTINUED --->