Specifications

131
9 EMERGENCY PROCEDURES
9.1 Emergency stop
During the regular work cycle it is allowed to stop movement
by releasing the control: stopping is immediate.
In the event of hazard or emergency situation, the machine or
equipment operation can be stopped using the emergency
push-button (Fig. 1-K0200); by pressing the stop push-button,
the machine and the equipment stop immediately.
The emergency stop push-button is located in the cab next
to any control position provided on machine or equipment.
 WARNING
Use of the Emergency stop push-button is
only recommended if an immediate danger
exists for the operator, the load and/or the
integrity of the equipment or the machine.
The pressure exerted on the Emergency stop push-button
cuts off the electric power supply and consequently switches
the vehicle off completely.
 DANGER
After a stop caused by the Emergency
stop push-button, return to normal work
conditions is only possible after:
• the removal of the cause of stopping
• release of the Emergency stop push-button
To release the Emergency stop push-button you must turn
the button in the direction shown by the arrows located
above the button.
S
T
O
P
-
S
T
O
P
-
S
T
O
P
-
S
T
O
P
-
S
T
O
P
-
1- K0200