Specifications

117
7.5.4 Flat-Face couplings removal
To disconnect the Flat-Face quick couplings:
1. Perform points 1, 2, 3 and 4 of the procedure for removal
of the equipment from the vehicle, described in the
previous chapter.
2. If there is a closed-centre distributor installed on the
vehicle, perform the procedures described in the
“Hydraulic hose connections” to discharge the pressure
present in the hydraulic circuit.
3. Switch the vehicle off
4. Turn the socket ring in a way to align the recess with
the position of the sphere on the socket (Fig. 10--I0400).
5. Push the socket ring (Fig. 11--I0400, pos.1).
6. Slide the plug out (Fig. 11--I0400, pos.1).
7. Remove any dirt from the plug and socket.
8. Carry out the same operations for both hoses.
9. Check that the hydraulic hoses are not entangled in the
tool-carrier plate or can be crushed by the equipment
when it is placed on the ground.
10. Proceed with the successive operations to remove the
equipment from the vehicle.
10- I0400
11- I0400
1
2