Specifications

113
7.5 Removing equipment
Follow the operations given below to re-position the
accessory once use has been concluded:
1. Position the vehicle on solid, fl at land.
2. Position the equipment on a support platform to
facilitate handling and transport of the individual piece
of equipment.
3. Lower and extend the vehicle boom by about one
metre.
4. Switch the engine off .
5. Remove any electric connections (consult next chapter).
6. Remove any hydraulic connections (consult next
chapter).
7. Remove the shear pins from the pins that fi x the
equipment to the boom plate.
8. Slide the pins out from the tool-carrier plate.
9. Turn the vehicle on and slew downwards in a way to
release the tool-carrier plate from the equipment.
10. Once the tool-carrier plate has been released, retract
the vehicle boom.
 WARNING
The accessory placed on the ground must
always be appropriately indicated and barriers
and separators must be positioned on all sides
of the area that it could occupy if falling.
 DANGER
After having discharged the pressure from
the system, always wait one minute before
disconnecting the joints.
 DANGER
Always disconnect the equipment hydraulic
hoses and electric cables before removing
it from the vehicle. On the contrary, the
hoses and cables could be damaged and the
equipment could fall and be dragged.