Specifications

100
11. Lift the locking pin “1” (Fig. 4-I0103) and insert the safety
pins 3” in their seats onto the tool holder plate, by
passing them through the corresponding slots of the
basket.
12. Insert the safety pin “2” on the pins already installed.
 ATTENTION
If the pins and relative shear pins should not
reach the correct position due to deformation,
the basket must not be used as it could unhitch
dangerously and fall to the ground.
 PROHIBITION
It is prohibited to operate without the safety
pin installed on the tool holder plate.
13. Carry out the electric and hydraulic connections (if
present).
Fur further information, consult the chapters
“Connections of hydraulic pipes” and
“Electrical cables connection”.
 ATTENTION
When using equipment that has hydraulic and
electric connections, these must always be
correctly connected to the vehicle. Failure to
connect does not allow regular operation of
the safety devices, with risk of injury/damage
to persons and objects and vehicle roll-over
hazard.
14. Once you have fastened the basket correctly, start the
machine and position the machine in work position.
15. Lower the stabilizers (if present) and keep the machine
levelled using the spirit level located in the cab for
reference.
16. Level the basket referring to the spirit level provided on
the basket.
17. Use the key selector (Fig. 5-I0103) to set the “Basket”
operating mode to enable the control push-button
panel located on the basket.
Refer to the use and maintenance manual
of the machine to set the proper operating
mode.
5- I0103
2
1
3
4- I0103