Specifications

99
7.2 Man basket installation
procedure
 DANGER
During this operation, make sure there is no
person in the vicinity of the machine or the
basket.
Perform the operations given below to install the basket
correctly:
1. Lower and completely retract the telescopic boom.
2. In the case of rotary machine, align the turret with the
frame.
3. Position all the levers in idle position, connect the
stationary brake and shut down the engine of the
machine.
4. Remove the safety pins “3” (Fig. 2-I0103) (if provided) by
removing the safety pins “2” and lifting the locking pins
“1”.
5. Rest the basket on a fl at, solid surface in order to hitch it
to the vehicle tool-carrier plate easily.
6. Start the machine and use the key selector (Fig. 3-I0103)
to set the operating mode “Forks”.
Refer to the use and maintenance manual of
the machine to set the operating mode.
7. Position the vehicle with the boom lowered parallel
to the basket. Approach the tool-carrier plate to the
basket, extending the telescopic boom.
 WARNING
The rotary vehicles cannot extend the boom
if it is lowered completely. Raise the boom
slightly in order to extend it.
8. Using the slewing movement, turn the tool-carrier plate
downwards. Bring the top part of the plate under the
equipment locking hooks.
9. Lift the boom slightly and turn the tool-carrier plate
upwards. By doing this, the equipment will adhere to
the vehicle tool-carrier plate.
10. Turn the engine off and get down from the vehicle.
1-I0103
2
1
3
3- I0103
2- I0103