Specifications

98
If using an aerial work platform.
- At the start of every work cycle, check that the load limiter and area limiter emergency buttons work correctly
- Before using the platform, check that it is not wet, dirty with grease or oil and has no frozen surfaces or is covered with substances
that may make the surfaces slippery. If this is not the case, clean the platform surfaces thoroughly. Slipping and falls hazard.
- The vehicle on which the equipment is assembled must be braked and stabilised on solid ground. If stabilizers are present
(optional), position them correctly on the ground before starting to operate.
- Before operating, make sure the platform closure bar is lowered and free from restrictions. Always check the safety belts are
attached correctly (PPD cat. III).
 ATTENTION
All checks must be made by suitably trained sta and recorded in the control register
Whenever any damage or malfunctioning is detected, follow the instructions contained in this manual or
contact the DIECI After-sales network to agree on the operations to be undertaken.
Whenever routine or extraordinary maintenance is necessary, or the equipment must be adjusted technically,
only contact sta authorised by the DIECI After-sales network and make note of the intervention in the control
register
Any tampering with the equipment makes any warranty and liability of the Manufacturer become null and
void
 DANGER
The user that detects the anomaly on the equipment or on the vehicle on which the same is installed, and
which does not comply with the Safety Standards, must suspend use and inform the Manager immediately.
For circulation on roads, refer to the Use and Maintenance Manual of the vehicle on which the equipment has
been assembled.