User's Manual
Table Of Contents
- 1 Manufacturer´s Certification
- 2 Supplier’s Declaration of Conformity
- 3 Introduction
- 4 Basic settings
- 5 Setting Up the Device
- 6 Overview
- 7 Projected Capacitive Touch Screen
- 8 Planning the Installation
- 9 Installation to a stand
- 10 Connector Panel
- 11 Storage Media
- 12 Installing System to a Wall
- 13 Mounting a Second Display (A1150/D1101)
- 14 Peripherals (optional)
- 15 Starting Up the System
- 16 Error Reporting
- 17 POST Code
- 18 Technical Data
- 19 Appendix
16
16 Error Reporting
When an error condition is detected, it is reported by a repetitive train of blinking red LED. Decode by
counting the number of blinks in a train and check against the error code table below.
Figure16-1: Error reporting
Number of
Pulse
Description of error Possible cause
1
SSD failed SSD may be faulty
2
NA
3
Processor Hot was activated Excessive load or thermal pads may be
degraded.
4
NA
5
Capacitive sense not present or faulty Cable loose or Capacitive sense board
may be faulty
6
Ambient Light Sensor/Proximity Sensor not
present or faulty
Cable loose or Capacitive sense board
may be faulty
7
PCH Hot was activated Excessive load or thermal pads may be
degraded.
8
Processor thermtrip was activated Excessive load or thermal pads may be
degraded.
9
DDR VR faulty Motherboard may be faulty
10
Cannot access configuration EEPROM Either docking board or motherboard is
faulty.
11
USB1 PD chip read/write error To recover do a cold reboot
12
USB1 PD chip execution error To recover do a cold reboot
13
USB1 PD chip not detected To recover do a cold reboot
14
24V DC-IN voltage in indeterminate region To recover do a cold reboot
Copyright © 2020, Diebold Nixdorf
01750342843B
16-1