User's Manual
Table Of Contents
- 1 Manufacturer´s Certification
- 2 Supplier’s Declaration of Conformity
- 3 Introduction
- 4 Basic settings
- 5 Setting Up the Device
- 6 Overview
- 7 Projected Capacitive Touch Screen
- 8 Planning the Installation
- 9 Installation to a stand
- 10 Connector Panel
- 11 Storage Media
- 12 Installing System to a Wall
- 13 Mounting a Second Display (A1150/D1101)
- 14 Peripherals (optional)
- 15 Starting Up the System
- 16 Error Reporting
- 17 POST Code
- 18 Technical Data
- 19 Appendix
Peripherals (optional)
Figure14-6: Fitting the Waiter Lock into the Beetle A Series
6. Insert the Waiter Lock module into the now
exposed USB port of the Beetle A Series.
7. Fit each knob on the Waiter Lock module
into its respective groove on the system as
indicated.
1
2
Figure14-7: Tightening the Waiter Lock screws
8. Then put on and tighten two M3x4 screws at
(1) and (2).
Figure14-8: Waiter Lock installed
9. Re-attach the side-attach peripheral connec-
tion cover.
10. Re-attach the Waiter Lock side cover.
11. The Waiter Lock is now installed.
Copyright © 2020, Diebold Nixdorf
01750342843B
14-4