User's Manual
Table Of Contents
- 1 Manufacturer´s Certification
- 2 Supplier’s Declaration of Conformity
- 3 Introduction
- 4 Basic settings
- 5 Setting Up the Device
- 6 Overview
- 7 Projected Capacitive Touch Screen
- 8 Planning the Installation
- 9 Installation to a stand
- 10 Connector Panel
- 11 Storage Media
- 12 Installing System to a Wall
- 13 Mounting a Second Display (A1150/D1101)
- 14 Peripherals (optional)
- 15 Starting Up the System
- 16 Error Reporting
- 17 POST Code
- 18 Technical Data
- 19 Appendix
Storage Media
11.2
11.2 Replacement of the RAM
1. First ensure that the device is switched off and the power connector is disconnected.
2. Proceed to replace the RAM with following the step below.
Figure11-6: Replacing the RAM
3. To unhook the RAM, locate the 2 latches (1)
and (2) by their sides.
4. Press them in an outwards direction (indi-
cated by the arrows).
5. The RAM is now unhooked and can be re-
moved and replaced.
6. When fitting in the new RAM, push it down-
wards until it latches on and a “click” sound
is heard.
Copyright © 2020, Diebold Nixdorf
01750342843B
11-3