User's Manual
Table Of Contents
- 1 Manufacturer´s Certification
- 2 Supplier’s Declaration of Conformity
- 3 Introduction
- 4 Basic settings
- 5 Setting Up the Device
- 6 Overview
- 7 Projected Capacitive Touch Screen
- 8 Planning the Installation
- 9 Installation to a stand
- 10 Connector Panel
- 11 Storage Media
- 12 Installing System to a Wall
- 13 Mounting a Second Display (A1150/D1101)
- 14 Peripherals (optional)
- 15 Starting Up the System
- 16 Error Reporting
- 17 POST Code
- 18 Technical Data
- 19 Appendix
Storage Media
Figure11-3: Exposing the components
6. Turn the back cover over to expose the com-
ponents as shown.
1
2
Figure11-4: Removing the SSD
7. Remove the screws (1) and (2) on the SSD.
NOTE
Screw (2) is attached to an optional sec-
ond SSD, which may or may not be
present depending on your system config-
uration.
8. The SSD can now be removed from their
slots by pulling downwards in the direction
indicated (arrow).
1
2
Figure11-5: Inserting a new SSD
9. Insert the new SSD by pushing it into the slot
in the direction indicated (arrow).
10. Put back and tighten the SSD screws (1) and
(2) previously removed.
11. The back cover can now be assembled back
onto the system.
Copyright © 2020, Diebold Nixdorf
01750342843B
11-2