User's Manual
Table Of Contents
- 1 Manufacturer´s Certification
- 2 Supplier’s Declaration of Conformity
- 3 Introduction
- 4 Basic settings
- 5 Setting Up the Device
- 6 Overview
- 7 Projected Capacitive Touch Screen
- 8 Planning the Installation
- 9 Installation to a stand
- 10 Connector Panel
- 11 Storage Media
- 12 Installing System to a Wall
- 13 Mounting a Second Display (A1150/D1101)
- 14 Peripherals (optional)
- 15 Starting Up the System
- 16 Error Reporting
- 17 POST Code
- 18 Technical Data
- 19 Appendix
Installation to a stand
1
7. Tilt the system back to its operating position.
8. Replace the VESA cover (1) by pushing it
upwards.
NOTE
When uninstalling the stand, always make sure that all cables are disconnected.
9.2
9.2 Installing system to the stand (with I/O hub)
9.2.1
9.2.1 Preparing the stand
1
1. Remove the I/O Hub cover by pulling it up
from the back.
Copyright © 2020, Diebold Nixdorf
01750342843B
9-4