User's Manual

Table Of Contents

Manufacturer´s Certification

1.7

1.7 Safety Notes

The Beetle A Series conforms to the current safety standards for data processing equipment.

• If this device is taken from a cold environment into the operating room, moisture condensation may

form. The device must be absolutely dry before being put into service; an acclimatization period of at

least two hours must therefore be observed.

• This device is equipped with a safety-tested power cable and may be connected only to a prescribed

grounded-contact power socket.

• When setting up the device, ensure that the power socket on the device and the grounded-contact

power socket are easily accessible.

• Whenever work of any kind is done on the device, as well as when data cables are plugged and/or

unplugged, the device must be completely disconnected from the line voltage. To do so, turn the de-

vice off and unplug the power cord.

• To disconnect the device from the supply voltage completely, switch off the device and disconnect

the power plug of the system.

• Never plug in or unplug data communication lines during thunderstorms.

• Protect devices from vibrations, dust, moisture and heat.

• Always dispose of used parts, such as batteries, in an environmentally safe manner.

• In emergencies (e.g. damaged housing or damaged power cable, penetration by liquids or foreign

bodies), the device must be switched off immediately, the power plug disconnected and the Cus-

tomer Service of Diebold Nixdorf or your dealer must be notified.

• Your Beetle A Series system is the result of modern technical innovation. So please see for accord-

ing structural and technical surroundings to guarantee a faultless and efficient work of your

Beetle A Series. Therefore, you should connect your Beetle A Series, or other IT-devices only to

power supply systems with separately guided protective earth conductor (PE). This kind of electricity

system is known as TN-S network. Do not use PEN conductors!

• Please also observe the recommendations of the norm DIN VDE 0100, Part 540, Appendix C2 as

well as EN50174-2, §5.4.3.Thus you can help to avoid possible malfunctions.

• Only use the storage medium recommended or approved by Diebold Nixdorf.

• This equipment is not suitable for use in locations where children are likely to be present.

• "CAUTION: Risk of Explosion if Battery is replaced by an Incorrect Type. Dispose of Used Batteries

According to the Instructions."/“ATTENTION: Risque d’explosion si la batterie est remplacée par un

type incorrect. Mettre au rebus les batteries usagées selon les instructions.“

• Please avoid extreme conditions, such as:

– high or low extreme temperatures that a battery can be subjected to during use, storage or trans-

portation.

– low air pressure at high altitude.

• Replacement of a battery with an incorrect type can cause an explosion.

• Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery can result

in an explosion.

01750342843B

1-6