Installation guide

~Dlce::
.... ·.-ELECTRO;\~lCS
Sc - Cable modification (only fori-VW-Rkit) -If veh ide is equipped with factory Satell ite rad io and desi red to be retained,
aharness modification
is required.
VW-R2
connector
;;1
~ffiEEB
G
6 Put plastic connector covers
back on.lnsertVW-R2
connector
to factory VW main
harness.
7 Connect ground wire
to
chassis of radio.
pinsl,3,7 ~
t )11"",
4 Remove the SAT wires from
the factory connector by
releasing
the pins with a
small screw driver or ball-
point pen.
pins 1,3,7
~
5 Relocate wires to VW-R2
connector keeping the same
order and location.
2 Slide
out the inner part of the
SAT connector from plastic
housing.
3 Disassemble
the VW-R2
connector the same way as
the factory SAT connector.
SAT
connector
;;1
~
ttEHE
~
,lr G 1_
1 Disconnect main radio
harness and locate
SAT
connector. Remove it from
main harness by pressing on
the release tab of the SAT
connector.