Instructions

www.diclaadsystemen.nl
27
NL
DE
EN
6 USE CHARGING STATION
Connect the test box to the car simulation in the 1st Mennekes connector and
scan the supplied test card with the DIC Card reader.
- The charger gives 1 short beep tone: Card is recognized
- The charger gives 1 short beep, followed by 3 short beeps and lamp flashes red:
card is unknown
Attention: The map is verified online, this may take some time depending on the
network availability. During this process, the LED lamp flashes green.
If the card is recognized:
The charging process starts when the LED light turns blue, at this moment the plug
is automatically locked.
Stopping charging
- The charger emits a short beep and the card is recognized, the LED turns green
and the plug is unlocked.
- When the charger gives 1 short beep followed by 3 short beeps and the lamp flashes
red the card is not recognized. Also test the other connector in the same way
7 DISTURBANCE
Contact the DIClaadystemen helpdesk directly phone [phone] if the green
LED lights do not light and the charging station cannot connect. Make sure that you
are on location where the charging station is located.
We read out the fault remotely if possible, it can happen that the charging station is
de-energized. If it is not possible to remotely correct the fault, follow these steps: