Operation Manual

11
CAUTION
DO NOT ATTEMPT TO REUSE FIRED PELLETS OR PEL-
LETS WHICH ARE DEFORMED. PROJECTILES SUCH AS
STEEL SHOT (BBS) AND DARTS MAY DAMAGE YOUR
AIR RIFLE AND CAUSE INJURY TO YOURSELF OR BY-
STANDERS DUE TO RICOCHETING, AND WILL VOID
THE WARRANTY.
WARNING
LEAD PELLETS CONTAIN LEAD, A CHEMICAL KNOWN
TO THE STATE OF CALIFORNIA TO CAUSE CANCER
AND BIRTH DEFECTS OR OTHER REPRODUCTIVE
HARM. DO NOT INHALE DUST OR PUT LEAD PELLETS
IN MOUTH. WASH HANDS AFTER HANDLING. KEEP
AWAY FROM CHILDREN.
8
. Adjusting the Sights: Models 240 Classic, 280 Series,
two-fifty, 340 N-TEC Series, 350 N-TEC Magnum Series
REAR SIGHT
DIANA Air Ries are equipped with a micrometer rear
sight, with vertical and hori-
zontal adjustment at the rear.
ELEVATION SETTINGS
If the rie shoots high: turn
the screw [A] clockwise (see
Illustration 7a). If the rie
shoots low: turn the screw
[A] counterclockwise (see Illustration 7a).
Note:
the numbers 0 – 9 are reference numbers only and
are not calibrated to distances.
WINDAGE SETTINGS
Windage settings are controlled by turning the knob
[B] on the side (see Illustration 7a). If the air rie shoots
to the right: adjust counterclockwise. If it shoots to the
left: adjust clockwise.
FRONT SIGHT
DIANA Models 48, 52 and 54 are equipped with an ad-
justable front sight ([C] – see
Illustration 7b. It can be ad-
justed by loosening the screw
[D], move it by sliding to a
lower or higher position. Af-
terwards retighten the screw.
Illustration 7a
A
B
Illustration 7b
C
D