Owner's Manual

HANDLING & OPERATION

The CHASER RIFLE model can be modified

into a CHASER PISTOL (and back again).

To do so, the stock and the barrel must

each be replaced as appropriate.

RIFLE – PISTOL CONVERSION APPLIES ONLY TO THE CHASER RIFLE MODEL

WARNING

BE SURE TO UNLOAD AND UNCOCK THE AIRGUN BEFORE PROCEEDING TO ANY

MODIFICATION!

1. Using a hexagon (Allen) key, loosen the

three barrel fastening screws 1. Loosen the

screw 2 of the barrel band 3 and remove the

band. In the next step, pull out the barrel of the

rifle (as shown in the figure)

and install the pistol barrel. Then re-tighten

the barrel fastening screws completely.

Finally, mount the rear sight 4 supplied with

the airgun.

2. Detach the rifle‘s stock screw 5 and

remove the stock 6 by pulling it backwards.

Slide the pistol‘s grip cap 7 onto the grip and

re-tighten the stock screw.

3. If you wish, you can swap* the muzzle cap

8 for the silencer 9.

*Note: Legislation in some countries may

require the airgun to be designed in such

way that the silencer cannot be detached.

2 3