User`s guide

Setting the Standard VGA Under Windows NT 4.0

To set your display to Standard VGA under Windows NT 4.0:

1. From the Start menu, go to Start > Settings > Control Panel, then

double click on Display. The Display Properties sheet appears.

2. Click on the Settings tab, then click the Display Type button.

3. Under Adapter Type, click on the Change button. The Change Display

window appears.

4. Under Manufacturers, select Standard Display Types. Under Display,

choose VGA Compatible Display Adapter.

5. Click on OK. You may need to insert your Windows NT 4.0 CD-ROM.

6. Click on Close and OK to accept the changes.

7. Shut down your computer. You are now ready to remove your old

graphics card and install your new Viper V770 board.

Note— You should have the latest Service Pack for NT 4.0 (Service Pack 4)

loaded for the Viper V770 to operate properly. Service Pack 4 is available

from Microsoft’s web page, www.microsoft.com.

After you have completed the steps above and removed your old graphics

card, you can continue with the procedures below to install your Viper V770

board.

Installing Your Viper V770 AGP Board

Installing your card should take just a few minutes. Please note that the

illustrations provided in this section are for instructional use only; the card

shown may look different than the one you purchased. To install your AGP

card, follow these steps:

1. With the power off, remove your computer cover and locate the AGP slot.