Specifications

DISSOLVE AND FORCE EFFECTS

Dissolve and Force

86 Operation Edition 1.08 CXPS Manual

See “Standard Window Function” on page 59 or “Picture-In-Picture” on page 60 for

instructions on setting up standard windowing or picture-in-picture modes.

EXAMPLE

Set Output 2 to display as a window in the foregrounds of Outputs 1 and 3 by

issuing the picture-in-picture commands:

PIPON 1 2 1

PIPON 3 2 3

Then set Output 8 to display as a window in the foregrounds of Outputs 5 and 6 by

issuing the commands:

PIPON 5 8 5

PIPON 6 8 6

STEP 2. SET SIMULTANEOUS DISSOLVE PAIRS

To set up simultaneous dissolve settings, use the command:

SDO <preset #> <dissolve rate> <output #> <from source> ...

Where:

• <preset #> refers to the preset slot (1-10) to which you would like to store dissolve

pairs.

• <output #> <from source> represents a dissolve pair.

• <output #> is the output or window whose video is gradually replaced by the video

from <from source>.

It is a number 1-36 corresponding to the output channel connected to the window/output

you would like to select.

• <from source> is the output or window whose video replaces the video from

<output #>.

It is a number 1-36 corresponding to the output channel connected to the window/display

you would like to select, or the number 100 to dissolve to black.

• <dissolve rate> is the number of frames (1-1024) for the dissolve effect.

NOTE:

When dissolving from a window to its background, <output #> and <from

source> will both be the number of the channel connected to the chosen

output display.