Specifications

. . . . .
DISSOLVE AND FORCE EFFECTS
Dissolve and Force
CXPS Manual Edition 1.08 Operation 85
• Issuing this command again will reverse the effect.
EXAMPLE:
In Dissolve Setup (Step 1), you set up a dissolve effect to dissolve from the video
on Output display 1 to the video on Output display 2. Once the Dissolve is
complete, you would like the video that had appeared on Output display 1 to
immediately display on Output display 2. The command is
DISFF 1
TO DELETE DISSOLVE SETTINGS
To reset output parameters to default settings, use the command:
DISDEL <output #>
Where:
• <output #> is identical to the output number specified in setup.
Simultaneous Dissolve Output
The Simultaneous Dissolve Output (SDO) commands allow users to simultaneously
dissolve multiple groups of windows or outputs by storing output-source pairs in ten
different preset slots. A user may also dissolve from multiple windows to their
backgrounds- this will fade the chosen windows away, revealing the portions of the
background that had previously obstructed.
The maximum number of dissolve pairs is equal to the maximum channels installed. The
steps needed to simultaneously dissolve are listed below.
STEP 1. SET UP WINDOWING IF DESIRED
If you would like to simultaneously dissolve windows, you must set up windowing mode
prior to setting up the simultaneous dissolve effect.
NOTE:
The DISFF command can only be used when dissolving between two
output channels that are NOT under windowing mode.
These channels must be connected to display screens.
NOTE:
Before setting up the simultaneous dissolve effect, the timing of each
output channel involved must be synchronized to the first output
channel on that card. See “Output Timing Synchronization” on page 78.
If you plan to simultaneously dissolve between channels on different
cards, you will have to follow synchronization procedure several times-
once for each card involved, before setting up the dissolve effect.