Specifications

DISSOLVE AND FORCE EFFECTS
Dissolve and Force
82 Operation Edition 1.08 CXPS Manual
Dissolve and Force
The Dissolve commands allow the user to dissolve or force one window or output. The three
steps involved are listed below.
STEP 1. SET UP WINDOWING IF DESIRED
If you would like to dissolve or force a window, you must set up windowing mode prior to
setting up the dissolve effect.
You can choose to use either standard windowing mode or picture-in-picture mode. For
instructions on setting up standard windowing, see “Output Timing Synchronization” on
page 57 or see “Picture-In-Picture” on page 60 for help setting up picture-in-picture mode.
FIGURE 21. The Force Effect