Specifications

. . . . .
DISSOLVE AND FORCE EFFECTS
Output Timing Synchronization
CXPS Manual Edition 1.08 Operation 79
you will have to follow synchronization procedure several times- once for each card
involved- before setting up the dissolve effect.
There are two different procedures to follow when synchronizing output timing- one for
when the output display screen used in the effect is connected to the first channel on the
card, and one for when it is not.
When the Display is Connected to the First Channel on the Card:
OUTPUT TIMING SYNCHRONIZATION
Before setting up the dissolve or force effect, issue the Framesync command, which
synchronizes the output timing of each output channel that will participate in the dissolve
effect to that of the first output channel on that card.
The command is:
FRAMESYNC <master> <slave1>...<slave3>
Where:
• <master> is the first channel on the card, to which the display is connected.
• <slave1>...<slave3> are the other channels on the same card as <master> that you would
like to use in the dissolve or force effect (the “before” video and the “after”)
EXAMPLE
Suppose you want to dissolve on output display 5, which is connected to output
channel 5. This would mean that the display is connected to the first channel on
the card, as shown in Figure 20. If you want to dissolve from output channel 6 to
output channel 8 on display 5, you would first need to synchronize the output
timing of output channels 6 and 8 to that of output channel 5. The command
would be:
FRAMESYNC 5 6 8
NOTE:
If you will be forcing, dissolving, or simultaneously dissolving to black
ONLY (not between any output channels), you do not need to
synchronize output timings before setting up the dissolve or force effects.