Specifications

INSTALLATION INSTRUCTIONS
System Reset
34 Installation Edition 1.08 CXPS Manual
The static IP address, subnet mask, and IP address gateway of the control computer are
set.
6 Open the Mozilla Firefox web-browser and type the CXPS IP address set in Step 4 into
the address bar of the browser and press Enter.
The GUI will be invoked and control of the CXPS is now done through the GUI. Details of the
web-server GUI controls are in Chapter 7, “Matrix Switching.”
Because the CXPS now has a static IP address, the RS-232 interface is no longer required. If
the IP address of the CXPS is misplaced, simply reconnect the RS-232 controls and use the
SHOWNET command to retrieve the IP address.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SYSTEM RESET
Occasionally, the CXPS CPU may need to be reset. Prior to installing the equipment in its
final position, you can simply power cycle the unit using the power switch on the rear panel.
However, once the unit is installed, it may not be easy to access the rear panel. In this
situation, you can use the RS-232 serial command: RESET.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CHANGING I/O CARD CONFIGURATION
Input and output cards may be added or removed from the CXPS as needed. The following
is applicable for Firmware versions 4.85 and previous.
After installing a new card:
1 Issue the RESTOREDEFAULT command to restore the factory defaults for user
parameters.
The command syntax is: RFD
2 Issue the command RSTOUTPUTATTR to reset the output gamma, lower, upper,
brightness, and contrast to the default values.
The command syntax is: RSTOUTPUTATTR
NOTE:
The system reset mimics a power cycle and does not affect your system
configuration settings, such as matrix routing settings.
NOTE:
If you are installing a USB card in a CXPS that did not previously contain a
USB card, contact Black Diamond Video at [phone] for assistance.
Technical support will provide a command to change the product type of
your unit from CXPS to CXPS_USB.