Specifications

. . . . .
INSTALLATION INSTRUCTIONS
Final System Installation
CXPS Manual Edition 1.08 Installation 31
To exit the network connection, enter the command exit.
10/100T ETHERNET ONLY
1 Connect the control computer directly to the CXPS with an RS-232 direct-connect type
cable and a 10/100T Ethernet crossover cable.
2 Set the static IP address of the CXPS:
a
Establish RS-232 control of the CXPS as described in “RS-232 Only” on page 29.
b Issue the IPADDR command using the static IP address assigned to the CXPS. For
example:
IPADDR 192.168.1.103
The CXPS is assigned the static IP address 192.168.1.103.
3 Set the static IP address of the control computer. If you are using Microsoft Windows,
follow these steps:
a
Click Start > All Programs > Accessories > Communications > Network Connections.
The Network Connections window appears.
b Right-click on Local Area Connection and select Properties.
The Local Area Connection Properties window appears.
c Click on Internet Protocol (TCP/IP) to highlight it and click Properties.
The Internet Protocol (TCP/IP) Properties window appears.
d Select Use the following IP address and enter the static IP address assigned to your
control computer into the IP address field.
For example, enter 192.168.1.10.
e Click on Subnet mask and the number 255.255.255.0 should appear.
f Enter the static IP address in the Default gateway field.
For example, enter 192.168.1.1.
g Click OK.
NOTE:
If the CXPS is powered off for several days, when the equipment is
powered back on, the DHCP server within the network may issue a new IP
address. If this happens, 10/100T Ethernet control can only be restarted by
beginning at Step 3 and determining the new IP address using the RS-232
SHOWNET command again.