Specifications

INSTALLATION INSTRUCTIONS
Final System Installation
30 Installation Edition 1.08 CXPS Manual
On Microsoft Windows, you can use HyperTerminal for serial communications.
3 Configure the port settings as follows:
• Baud: 9600
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: None
The RS-232 connection to the CXPS is established and the processor can be controlled using
the RS-232 command set found in Appendix A, “RS-232 and 10/100T Protocol.”
10/100T ETHERNET AND RS-232
1 Connect the CXPS to your network using the Ethernet connector.
2 Connect the RS-232 control computer to the CXPS with an RS-232 direct-connect type
cable.
3 From the RS-232 control computer, determine the CXPS IP address:
a
Establish RS-232 control of the CXPS as described in “RS-232 Only” on page 29.
b Enter the command: SHOWNET (see Appendix A, “RS-232 and 10/100T Protocol,” for
details).
The CXPS IP address is returned.
4 From the Ethernet control computer, which must be connected to the same network as
the CXPS, open All Programs > Accessories > Command Prompt and enter the
command telnet <IP address> 8998 using the IP address obtained in Step 3.
The Telnet session is initiated.
5 Enter the network password.
The default network password is “blackdiamond”.
Telnet control is established. See
Appendix A, “RS-232 and 10/100T Protocol,” for a list of
key commands and how they are used to control the CXPS.
NOTE:
To avoid recreating the connection parameters each time you reestablish
RS-232 connection to the CXPS, you can save the connection for
subsequent hyperterminal sessions.
NOTE:
The RS-232 control computer and the Ethernet control computer can be
the same machine or two different machines.