Specifications

. . . . .
INSTALLATION INSTRUCTIONS
Final System Installation
CXPS Manual Edition 1.08 Installation 27
DESCRIPTION
Connect all DVI or fiber-capable displays to the CXPS output channels. See Figure 7,
“System Installation Overview Diagram,” on page 27 for an illustration of a typical CXPS
system diagram.
1 Connect DVI (or fiber) cable to first DVI (or fiber) output of the CXPS.
2 Connect the other end of the cable as follows:
a
If the DVI cable is more than seven meters in length, connect it to the input of the DVI
X-treme II Conditioner. Connect a second DVI cable, no more than seven meters in
length, to the DVI display device.
b If the DVI cable is less than seven meters in length, connect it directly to the DVI display
device.
c For cable distances over 60 meters, use fiber cable to connect the CXPS to the display
device.
3 Repeat Steps Step 1 and Step 2 for all other DVI and fiber output channels to be used in
your installation.
FIGURE 7.
System Installation Overview Diagram
NOTE:
Displays capable of accepting dual-link DVI signals should be connected to
output channels located on the DVI cards in odd-numbered slots. See
“Dual-Link vs Single-Link” on page 12 for more information.