Specifications

INSTALLATION INSTRUCTIONS
System Test Installation
24 Installation Edition 1.08 CXPS Manual
3 Connect Output 1 of the CXPS to the display using Black Diamond Video tested DVI (or
fiber) cable.
If a DVI X-treme Cable Kit is needed, do the following:
a Connect the long length of cable from Output 1 of the CXPS to the input of the DVI X-
treme II Conditioner.
b Connect the output of the DVI Xtreme II Conditioner using the short length of DVI cable
to the display. The red indicator light on the DVI X-treme II Conditioner indicates a
good DVI signal is being transmitted to the display.
4 Within the serial port terminal, type in the command: sw 1 1.
Input 1 is switched to display to Output 1. Video should now be displayed on your test output
device.
5 Move the output cable from Output 1 to Output 2 so that Output 2 is now connected to
the display device.
6 Within the serial port terminal type in the command: sw 1 2.
Input 1 is switched to display to Output 2. Video should again appear on the test output
device.
7 Repeat steps Step 5 and Step 6, moving the output DVI or fiber cable to each of the
remaining output channels in turn. Use the SWITCH command to route the video
through the connected channel. Verify the video displays properly through each output
channel, for all DVI and fiber outputs.
8 Move the input DVI or fiber cable from Input 1 to Input 2 so that Input 2 is now
connected to the test signal source.
9 Within the serial port terminal, type in the command: sw 1 [output #], where
[output #] is the output channel which is currently connected to your test display
device.
10 Repeat Step 8 and Step 9, moving the input cable to each of the remaining input
channels in turn, using DVI or fiber cable as needed. Use the SWITCH command to
route the video from the connected channel. Verify the video displays properly coming
from each input channel, for fiber and DVI inputs.
This completes the system test installation.
NOTE:
If the distance to the display requires more than seven meters of DVI cable,
a Black Diamond Video DVI X-treme Cable Kit should be used with the DVI
X-treme II Conditioner.