Specifications

GETTING READY TO INSTALL
System Test Installation Overview
16 Installation Edition 1.08 CXPS Manual
The system test installation consists of four steps. These steps are described below and
illustrated in Figure 6.
Step 1. Establish Temporary Remote Control of the CXPS
Establish temporary remote control of the CXPS through a laptop computer or personal
computer using the RS-232 serial interface. This allows control of the CXPS so that the
video signals going into and out of the processor can be tested.
Step 2. Connect Test DVI and Test Fiber Input Sources
Connect one fiber video source to the first fiber input on the CXPS (if applicable). Connect
one DVI video source to the first DVI input on the CXPS. In Figure 6, the first fiber input is
input 1 and the first DVI input is input 13. Only a single DVI source and single fiber source
are required for the system test installation phase. Use Black Diamond Video tested DVI
and fiber cable to connect your test sources to the CXPS.
FIGURE 6. CXPS System Test Installation Diagram
NOTE:
If the computer you used in Step 1 has a DVI output, you can use it for the
test DVI video source in this step. This computer should have a built-in DVI
graphics card.