Specifications
. . . . .
PRODUCT INFORMATION
Rear Panel Detail
CXPS Manual Edition 1.08 Introduction 7
On a fully-configured CXPS, Dual-Link DVI is supported on the following input
connectors: 1-4, 9-12, 17-20, 25-28, 33-36. Single-Link DVI is supported on all input
connectors.
For cable distances greater than seven meters, Black Diamond Video certified DVI cable
should be used. Black Diamond Video certified DVI cable is factory tested and guaranteed
for distances up to 60 meters. A DVI X-treme conditioner is not required on the input side
of the CXPS.
4 - DVI-O OUTPUT CONNECTIONS
The DVI-O output connectors are digital DVI outputs used to connect to a digital display
device. On a fully-configured CXPS, Dual-Link DVI is supported on the following output
connectors: 1-4, 9-12, 17-20, 25-28, 33-36. Single-Link DVI is supported on all output
connectors.
When connecting to a display device more than seven meters from the CXPS, a DVI X-
treme Cable Kit should be used with the DVI X-treme conditioner placed on the display side
of the cable.
5 - RS-232 SERIAL INTERFACE
The RS-232 interface is a DCE type used to control the CXPS by an external host over a
serial port or alternate RS-232 controller. A direct connect type RS-232 cable should be
used to connect the CXPS to a PC.
6 - 10/100T ETHERNET PORT
The 10/100T Ethernet port is used for controlling the CXPS from a remote location. This
port is also used for firmware upgrades in the field. The 10/100T Ethernet port can control
the CXPS through commands similar to the RS-232 port.
7 - GENLOCK INPUT/OUTPUT
The genlock I/O is used as an alternative external genlock source for the output scaler and
windowing cards. It is a general purpose +3.3V or +5V level genlock source.
8 - USB MATRIX SLOTS
Each USB matrix slot can accept a USB type B (input) or type A (output) card. Each card
supports 12 USB connectors.
9 - FIBER-I INPUT CONNECTIONS
The Fiber-I input connectors are used to connect a fiber video source to the CXPS.
10 - FIBER-O OUTPUT CONNECTIONS
The Fiber-O output connectors are fiber outputs used to connect to a fiber display device.