Specifications

. . . . .
RS-232 AND 10/100T PROTOCOL
CXPS Command Set
CXPS Manual Edition 1.08 Reference 105
CSM CSM Creates the startup macro. Issue this command,
then issue every command you would like stored
in the macro. When finished, press Esc and then
carriage return to end the session.
CUSTOMEDID CEDID <input #> <host>
<hsize> <vsize>
Sets the EDID timing from the host table.
<hsize> and <vsize> values are compared to
the resolution of the hosts in the host table. When
the first match is found, the timing of that host is
used to calculate the EDID value, which is then
programmed to the input channel. NOTE: Before
issuing this command, disconnect the input from
the source.
CEDID <input #> <host #> Sets the EDID timing from the host table.
Use when you know the host number.
DSM DSM Deletes the startup macro.
EXTCTL EXTCTL <ON|OFF> Enables/disables a special protocol for using an
external controller, such as Crestron or AMX to
control the CXPS.
FORCEOUTPUT FOUT <output #> <ON|OFF> Forces the specified output channel to send out a
signal even when the CXPS cannot detect a
connected display device.
NOTE: If a monitor is connected to the CXPS via
a fiber cable, there will be no hot plug, and thus the
output will be undetected by the CXPS. To combat
this issue, use the FOUT command to force output
detection.
FORCEOUTPUTALL FOUTALL <ON|OFF> Forces all the output channels to send out a signal
even when the CXPS cannot detect the connected
display devices.
NOTE: For firmware version 4.80 and above.
FRAMESYNC FRAMESYNC <master>
<slave1>...<slave3>
Frame-synchronizes all the slave channels to the
master channel.
GET8051 G8051 <input #> Reads back the RGB to DVI converter timing of
the selected input channel.
GETDVIINTIMING GDIT <input #> Returns the input DVI timing at the specified
channel.
GETDVIOUTTIMING GDOT <output #> Returns the output DVI timing at the specified
channel.
GETEDID GEDID <output #> Returns the EDID data from the display device
connected to the selected output channel.
GETEXTREME GEX <output #> Reads back the ID of the Extreme Cable
Conditioner at the selected output channel.
GFRAMESYNC GFRAMESYNC <start output #>
<end output #>
Synchronizes the frames of all outputs within the
range of <start output #><end output #> to the start
output.
SYSTEM COMMANDS
Command Syntax Action
. . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .