Specifications

. . . . .
RS-232 AND 10/100T PROTOCOL
CXPS Command Set
CXPS Manual Edition 1.08 Reference 101
ZM3 <output #> <output #>
<output #> <zi | zo | pl |
pr | pu | pd | stop> <speed>
Zooms or pans 3 outputs simultaneously. zi =
zoom in, zo = zoom out, pl = pan left, pr = pan
right, pu = pan up, pd = pan down, stop= stop the
process. Speed is 1 to 10.
NOTE: The 3outputs channels must be routed to
the same input. For firmware version 4.80 and
above.
SWITCHING COMMANDS
Command Syntax Action
. . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .
BRIGHTNESS BRI <input #> <bright> Adjusts the brightness of the input signal. RGB
and SD inputs only.
<bright> is a value from -100 to 100.
CLEAREFFECT CLREFFECT Clears all effects in memory, including SSO, SDO,
WINDOW, WALL, and DISSOLVE.
CONTRAST CONT <input #> <contrast> Adjusts the contrast of the input signal. RGB and
SD inputs only.
<contrast> is a value from 0 to 200.
COPYOUTPUTTIMING CPOT <from> <to> Copies output timing from one output to the other.
<from> is the number of the output whose timing
you are copying.
<to> if the number of the output who will be
receiving the copied output timing.
CREATEINPUTHOST CINHOST <slot #> <name>
<hfp> <hs> <hbp> <hact>
<vfp> <vs> <vbp> <vact>
<hfreq> <sync> <phase>
<vpol> <hpol> <interlace>
Creates an input host timing in the designated slot
number (1-40), with the specified parameters.
<slot #> is a number 1-40.
<name> is limited to 16 characters.
<hfreq> in Hz.
<sync> is 3,4, or 5 wire.
<vpol> is vertical sync polarity; 1 = positive, 0 =
negative.
<hpol> is horizontal sync polarity.
<interlace> is 1 = interlaced, 0 = non-
interlaced.
SCALING COMMANDS
Command Syntax Action
. . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .