Specifications

. . . . .
RS-232 AND 10/100T PROTOCOL
CXPS Command Set
CXPS Manual Edition 1.08 Reference 99
GAMMA <red|green|blue>
<output #> <value>
Adjusts the gamma of an individual color at the
output.
GENLOCK GL <output #> <ON|OFF> Genlocks the output timing to the associated input
timing.
GENLOCKALL GLALL <ON|OFF> Genlocks the output timing of all outputs to the
associated input timing.
OUTPUTWINDOWSIZE OWS <output #>
<FIT|FILL|CENTER|STRETCH>
Applies preset video positioning to the specified
output channel.
<FIT> fits the entire image onto the display,
maintaining the original aspect ration. Equivalent
to resetting the video scaling to the default auto-
resolution display.
<FILL> scales an image up or down to fill the
display, maintaining proper aspect ratio of the
input. Image will be cropped if the input and
output aspect ratios do not match
<CENTER> maintains native resolution of the
input and centers it within a display with a
different resolution.
<STRETCH> stretched an image to fit onto the
display without cropping when the aspect ratio of
the input is different than that of the display
device. The aspect ratio will not be maintained if
the image is stretched.
OWS <output #> <hsize>
<vsize>
Specifies a custom output resolution for the
specified output channel. Aspect ratio is not
constrained.
PAN PAN <output #> Activates controls to pan around the active
boundary of zoomed video of the selected output
or window. Control pan action with:
i - up, m - down, j - left, l - right q - quit
PIWS PIWS <output #> Special command. Retrieves the source window
and destination window values from the NVRAM.
PIWSALL PIWSALL <output #> Special command. Retrieves the source window
and destination window values from the NVRAM
for all outputs only if the outputs all share the same
input.
RSTDBUFFER RSTDBUF <output #> Resets the double buffer threshold to the factory
default value.
RSTOUTPUTATTR RSTOUTPUTATTR Resets the output gamma, lower, upper, brightness,
and contrast to the default values.
When using firmware version 4.85 or previous,
issue the RFD command and then this command
after installing a new board or updating firmware.
SFREEZE SFZ <output #> <output #>
... <output #> <ON | OFF>
Simultaneously freezes or unfreezes multiple
outputs.
SCALING COMMANDS
Command Syntax Action
. . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .