Specifications

WALL PROCESSING
Switching Input Sources
94 Operation Edition 1.08 CXPS Manual
This will cause the wall adjustment control field to appear, as shown in Figure 24.
Wall Position Adjustment Control:
• To move the wall’s position to the left one preset increment, press the lower-case “j”
key.
• To move the wall’s position to the right one preset increment, press the lower-case “l”
key.
• To move the wall’s position up one preset increment, press the lower-case “i” key.
• To move the wall’s position down one preset increment, press the lower-case “m” key.
Speed Control:
• To increase the adjustment speed, press the lower-case “f” key.
• To decrease adjustment speed, press the lower-case “s” key.
• Each time the “f” or “s” key is pressed, the speed is adjusted by 1 preset increment of
pixels.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SWITCHING INPUT SOURCES
The input source routed to a wall can be switched using the RS-232/Telnet Wall Switch
command. When selecting a different input to display on the wall outputs, issue the
command:
WALLSW <input #> <first output #>
FIGURE 24. The Wall Adjustment Control Field