Specifications
Cascade Modem Manual
Copyright © 2007 Diamond Traffic Products, Inc
Page 24
3.6. Factory Settings & Default States
Diamond Traffic Products pre-initializes all modems with the following command sequence:
57.6k Baud Model:
AT&FE0M1Q0V0X1\N5\Q0&C1&D2S0=2
AT\T9+GCI=B5 (COUNTRY CODE =US)
This sets the entire correct modem configuration into non-volatile memory so that it works on power up. This can
also be sent through the Centurion Software in the modem setup initialization lines or through any terminal
program manually.
These settings can be summarized as follows:
&F Restore factory defaults (see below).
E0 Do not echo commands
M1 Speaker on until carrier received
Q0 Turn On Result Codes
V0 Short form (number) responses
X1 Use results codes 0-5 & 10 (Extended Result Codes)
\N5 Error control V.42 or MNP required
\Q0 No flow control enabled
&C1 Make carrier signal match actual state.
&D2 Hangup modem on DTR transition.
S0=2 Answer phone after two rings.