Specifications

Cascade Modem Manual
Copyright © 2007 Diamond Traffic Products, Inc
Page 14
3.2. Status Messages & Result Codes
The modem responds with a status message after each command is executed and result codes after a modem
connection is made or attempted. The status messages may either be up to two digits (terse), followed by a
carriage return or may be a carriage return and line feed with a message in English (verbose) followed by a
carriage return and line feed. Short form and long form respectively
All AT commands, other than dialing commands, will be responded to with either an OK (0) if the command is valid
or accepted; or with an error (4) if the command is not recognized. All other messages fall in the category of call
progress status or result codes. Such as: Ring (2) - while the remote modem is being called, each ring will be
signaled to the DTE. No answer (8) will indicate a failed connection attempt. When the modem connects, result
codes will be signaled to the DTE.
Result codes from 1 - 102 are shown below.
The (default) connect messages 10 – 24 and 52-69 indicate a connection at a given DTE speed, not Carrier (Line)
speed. Certain subsets of status and result codes can be specified by the ATXn command. The basic status code
subsets are enabled with the Xn command. Where n=0,1,2,3,4, 5(all) the status codes can be in message form or
result code form. See the detailed description of the ATXn command for result code options.
Result Codes
XE5690SM Responses
Digits
Verbose
Description
0
OK
Command Successful
1
CONNECT
300 bps or higher connection
2
RING
Ring signal detected
3
NO CARRIER
Carrier not detected
4
ERROR
Error in command line
5
CONNECT 1200
1200bps Connection
6
NO DIAL TONE
No dial tone detected
7
BUSY
Busy signal detected
8
NO ANSWER
Remote does not answer
9
RINGING
Ringback signal detected
10
CONNECT 2400
2400bps Connection
11
CONNECT 4800
4800bps Connection
12
CONNECT 9600
9600bps Connection
14
CONNECT 19200
19200 bps Connection
15
CONNECT 7200
7200 bps Connection
16
CONNECT 12000
12000 bps Connection
17
CONNECT 14400
14400 bps Connection
18
CONNECT 16800
16800 bps Connection
19
CONNECT 21600
21600 bps Connection
20
CONNECT 24000
24000 bps Connection
21
CONNECT 26400
26400 bps Connection
22
CONNECT 28,800
28800 bps Connection
23
CONNECT 31200
31200 bps Connection
24
CONNECT 33600
33600 bps Connection
30
CIDM
Caller ID Detected
31
FLASH
Hookswitch Flash detected
32
STAS
UK Caller ID Alert detected
33
X
Over current Condition