Instruction manual

Phoenix II/Unicorn/Pegasus USB connector

4 Pin USB Female “B” Panel connector (front view)

4 pin Male USB “A” Side (PC side)

Phoenix II/Unicorn/Pegasus 25 Pin Male Modem Interface Cable

Phoenix II/Unicorn/Pegasus 9 Pin Connector (front

view)

25 Pin Female Sub-D Connector

#7 – Receive Data (RXD)

#3 – Receive Data (RXD)

#6 – Carrier Detect (DCD)

#8 – Carrier Detect (DCD)

#5 – Data Terminal Ready (DTR)

#20 – Data Terminal Ready (DTR

#3 – Serial Port Enabled (ENA)

#1 – Frame Ground (GND)

#2 – Signal Ground (GND)

#7 – Signal Ground (GND) (Shield)

#8 – Transmit Data (TXD)

#2 – Transmit Data (TXD)

NOTE: On the Phoenix II/ Unicorn/Pegasus 9 Pin connector, pins #9 and #4 are shorted together and have no wires

inserted, pin #2 and #3 are shorted together, pin #1 is not used, the RTS (#4) and CTS (#5) wires from the 25 Pin

Sub-D are soldered together and then sealed with heat shrink tubing, and pin#2 gets two wires.

Phoenix II/Unicorn/Pegasus 9 Pin Male Modem Interface Cable

Phoenix II/Unicorn/Pegasus 9 Pin Connector (front

view)

9 Pin Male Sub-D Connector

#7 – Receive Data (RXD)

#2 – Receive Data (RXD)

#6 – Carrier Detect (DCD)

#1 – Carrier Detect (DCD)

#5 – Data Terminal Ready (DTR)

#4 – Data Terminal Ready (DTR)

#3 – Serial Port Enabled (ENA)

(Shield)

#2 – Signal Ground (GND)

#5 – Signal Ground (GND)

#8 – Transmit Data (TXD)

#1 – 6VDC + Output to Modem (optional)

#3 – Transmit Data (TXD)

#9 – 6VDC + from UPP Batt (optional)