Instruction manual

Note the position of the cursor in the first digit of the time. Start entering the time

with hour, minute, and then second. For example, 3:30pm would be 15:30:00 and

zero seconds. Press ENTER when done.

Note once again the position of the cursor & that the date is in the format set in

Configure System. Enter the date, and press ENTER.

Use the arrow keys to toggle to the correct day. Press ENTER when done.

Press the number on the keypad which corresponds to the lanes you want to turn

“on”. n = not collecting y = yes collecting.

Use the keypad to enter the direction or some other piece of information about the

lane, for example: Eastbound

Press ENTER when done.

Since it is a two lane highway with a good chance of vehicles passing, press the

right arrow key to toggle the option to Yes.

Press enter when done.

Since we created a directional lane, we can now enter information about that

lane. For example: Westbound

Press ENTER when done.

Choose the sensor layout needed to collect data. This example shows axle

sensors (road tubes) in a two sensor layout. Select and Press ENTER.

Since our example road tubes are at 4.0’ (4 feet), type 0,4,0 and press ENTER.

Press the arrow keys to change the option to Enhanced Raw Data (Section 2.c.).

Press ENTER.

At this point, the next vehicle to cross the Axle Sensor will show as a test vehicle.

The first vehicle to cross in lane #1 will show something like the following screen: