Instruction manual

Select the voltage you want the counter to warn you that the battery is low. Use

the left arrow key to decrease the voltage or the right arrow key to increase the

voltage (default is 5.8).

4.i. View Lane Totals

This option allows you to view the total amount of vehicles (Raw “Per-Vehicle” and Binned Storage Modes) or Sensor

(Timestamp) activations (Count and Sensor Storage Modes) that have occurred from the last time you Started Collection

to the last time you Stopped Collection.

When you select this option, a screen will appear similar to the following:

If two or more lanes enabled.

If only one lane is enabled.

a and b are the lane numbers of enabled lanes and x and y are the total vehicles or sensor activations. If you are

collecting data then the totals will update as vehicles cross the sensors. To view additional enabled lanes, press the

<ENTER> key. To back up to view previous lanes press the <CLEAR> key.

If you use a preset time (such as Start At Midnight) then these lane totals will reset at the end of the preset time. Also,

using In-Day times will reset lane totals at the beginning of each In-Day period. Daily or Weekly files does not reset the

lane totals.

4.j. Cold Restart

We recommend that you do a Cold Restart whenever you can without losing valuable data. The reason is that there are

thousands of ways to attempt to program the Phoenix II but only a small percentage have the program structure coded

into the Phoenix II to cause it to function correctly. All others can introduce errors in the programming; a cold restart

erases all these erroneous programming commands and brings the counter back to factory defaults.

Cold Restart will perform the same function as removing backup power. The system will restart with ALL memory clean.

Note that time and date, along with ALL configuration parameters WILL BE LOST. Don’t use this option if the system

contains any data which has not been retrieved for use. ALL DATA IN MEMORY WILL BE LOST.

Press 7 from the menu and the screen will show:

Press ENTER to select option

If you are SURE you want to restart, use the arrow keys to toggle to YES. Press

ENTER. This cannot be stopped once underway.

“n.nn” is the version of the interior firmware. The “t” is the setup type (usually an

“A”).