Instruction manual

4.e. Show Status

The Show Status option allows display of the Phoenix II System Status. This should always be performed prior to

Starting Collection to ensure correct time/date and that there is enough memory free to collect files. From the menu

press “3” and the display will show:

Press ENTER to show the status of the counter.

If no loop boards are installed in the counter, the display shows:

Displays the total amount of memory in your counter, and how much is left

after use.

Next, how many files in the memory is displayed:

“n” = number of files.

If there are not any files.

Next, if there aren’t loop boards installed, the display will show:

This message tells the operator that the counter does not see any Loop

Boards installed.

If loop boards are installed, the display will show:

Where xxxx will be which loop boards are installed (1-4).

Next, the Piezo Boards status will show:

If no piezo inputs.

x Input Piezo“x” is number of piezo Board Installed

inputs available (0,4,or 8).

Next, the current time and date is shown:

The current time (military or 24 Hour format) and date are displayed. Note that

the date will be displayed in the currently selected format under the configure

system menu.

Last, the battery condition is displayed.